Cumberland Stove Works MF3800 Stove User Manual


 
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Page 10 800-345-6007
CumberlandStoveWorks.com
MOUNT DOOR
Take off protective cardboard. Hang door on hinges
making sure it’s seated properly so latch is aligned with
latchcut-out.
LATCH ADJUSTMENT
The door gasket may settle after use and adjustment to
latch is necessary to ensure proper seal. To adjust latch
remove roll pin and swap washers from the inside of door
to the outside of the door. Replace roll pin and inspect
doort.
MOUNTING THE CONTROLLER
The CSW MF Series Stove has three different controller
mountingoptions:
1. Back of the stove with controller visible.You may mount
theconrollteroneithersideoftherearofthestove(see
gure8)soitisvisibleduringoperation.Todosousethe
metalmountingbracketandthe(4)self-tappingscrews((2)
throughtheplasticbracketand(2)throughthebackpanel
ofthestove).Attachthroughthepre-drilledholes.
Note: Self-tapping screws must penetrate hopper.
2. Back of the stove with controller hidden. You may mount
thecontrolleroneithersideofthestove(seegure9).Soit
is not visible during operation. Attach the plastic mounting
brackettothepre-drilledholesoneithersideofthestove
usingthe(2)self-tappingscrews.
Note: Self-tapping screws must penetrate hopper.
3.Wallmounted(gure10).Youmaymountthecontroller
onthewallnexttotheunitusingtwodrywallscrews.Itis
besttoembedthescrewsintoastud.Useastudnderto
locate studs in the wall.
PLUG STOVE INTO CONTROLLER
After mounting the controller plug the phone cord from the
back of the stove to the underside of the controller.
Figure8:Controlleronmetalbracketinback.
Figure9:Controlleronplasticbracketinback.
Figure10:Controlleronwall.
Figure11:DoorLatchAdjustment.