Cumberland Stove Works MF3800 Stove User Manual


 
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Page 18 800-345-6007
CumberlandStoveWorks.com
WARNING
NEVER SHUT DOWN YOUR STOVE BY LEAVING THE
HOPPER DOOR OPEN AND UNATTENDED. THIS COULD
CREATE AN UNSAFE CONDITION IF THE DWELLING IS
UNDER NEGATIVE PRESSURE.
THERMOSTATIC CONTROL OPERATION
The stove has been designed to be run thermostatically
twodifferentways.Thereisabuilt-inthermostatinthe
controller,oraremotethermostatcanbeinstalled(see
INSTALLINGREMOTETHERMOSTATpage14).
LOCAL T-STAT – The local thermostat is the thermostat
located inside the controller display. To use this mode
press the thermostat button until the following screen is
displayed:
LOCAL TSTAT
TheL.E.D.lightlocatedinthetoprightcornerofthet-stat
button will illuminate. During normal local thermostat
operation the screen will display (for example) the
following:
STPT 72 TEMP 65
RANGE 3 LEVEL 4
During local thermostat operation the TEMP UP and TEMP
DOWN buttons control the thermostat setpoint.
REMOTE T-STAT–RemoteT-STATmodeischosenby
pressingtheT-STATbuttonuntilthefollowingscreenis
displayed:
REMOTE TSTAT
.
During this thermostat mode the stove is controlled by a
thermostat that is placed far from the stove. If the stove
isinthismodethescreenwilldisplay(forexample)the
following:
REMOTE * TEMP 72
RANGE 3 LEVEL 4
NOTE:Theasterickindicatesthatthetermostatiscalling
for heat.
To turn off the thermostat mode press the thermostat button
untilthefollowingscreenisdisplayed:
TSTAT OFF
.
This will return the stove to manual operation where the
heat level is controlled by using the Temp Up and Temp
Down buttons.
At anytime during normal operation you may press the
OFF button to safely shut down the stove. IMPORTANT:
NEVER UNPLUG YOUR STOVE WHILE THERE IS FUEL
BURNING IN THE STOVE.Thestoveisdesignedtoexhaust
smoke through the vacuum created by the combustion fan.
Doing so will cause combustion fan to stop and smoke will
enter the room through air intake holes.
EXPLANATION OF FAULT MESSAGE SCREENS
OVERTEMP RESET
SWITCH
Allow the stove to cool then reset the overtemp switch
located inthe back of theunitunderthe exhaust vent.
Seegure1.
AUGER OVERTEMP
RESET SWITCH
Allow the stove to cool then reset the overtemp switch
locatedontheaugerhousing.Seegure2.
Note: An overtemp switch will not reset until the stove
has cooled to an acceptable level. To reset the switch you
must manually press in the button located on the switch.
Seegures1&2forswitchlocations.Intheeventofan
overtemp you must either select a lower fuel range for
your selected fuel or clean the stove. Cleaning the stove
isnecessarytomaximizeheattransferfromthestoveto
the room.