Filter
Top Products
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Page 9800-345-6007
CumberlandStoveWorks.com
UNPACKING AND ASSEMBLY
Unpack all hardware located in the units hopper and ash
pan.Thefollowingshouldbeincluded:
4-legs(710008)w/levelers(725010)
4-tie-downstraps(700136)
1-repotcleaningrod(700076)
1-cleaningrodspring(720053)
1-hopperlidhandle(730006)
1-powercord(720045)
1-scrapertool(700225)
1-door(700311)withglass(720002)
andhandle(700351,700359)
1-controller(730053)
1-steelmountingbracket(700349)
1-pre-madepartsbag(small)whichincludes:
4-1/4-20x2”tie-downbolts(725015)
2-8-32x3/8”hopperlidhandlebolts(725012)
12-5/16-18x3/4”legbolts(1501)
4-#8-18controllerbracketscrews(725027)
MOUNT LEGS
NOTE: Stove is heavy. Team lifting is recommended.
1. Gently tilt the stove on its side.
2. Assemble the legs using provided (12) leg bolts as
showningure4.
NOTE for MOBILE HOME INSTALLATION: If unit is
to be used in a mobile home, you must install the
(4) tie-down straps to the stove now. Refer to page
15 for instructions.
3. After all bolts have been tightened, set the stove back
up on its legs.
MOUNT HANDLE TO HOPPER DOOR
1. Using a Phillips screwdriver, attach hopper handle to
hopperdoorusingthepre-drilledholes.Seegure5.
ASSEMBLE FIREPOT CLEANING ROD
1.Threadspringovernon-threadedendofrod.
2. Place threaded end of repot cleaning rod through
decorativecastingandscrewintorepot.Seegure
6.
NOTE: It is important for the re pot to slide freely in
and out of the pot holder. Fire pot must seal tight
when pushed in.
PLUG IN POWER CORD
1.Plugpowercordintothebackofstove.Seegure7.
Figure4:LegAssembly
Figure6:AshShuttleRodAssembly
Figure5:HopperDoorHandleAssembly
Power Cord Receptacle
Figure7:AshShuttleRodAssembly