Filter
Top Products
Commercial Lighting Design Guide Integrated Shade and Drape Controllers
Doc. 4775A 84
Integrated Shade and Drape Controllers
C2N-SDC
The C2N-SDC is a 2-channel shade and drape controller designed to provide a
convenient and cost-effective solution for controlling a variety of motorized window
treatments as well as motorized doors, sunroofs, lifts and projection screens.
The C2N-SDC is a Cresnet® device with two independently controlled 120V AC outputs.
Each output provides up/down or open/close control of a conventional 3-wire
bidirectional type motor. Built-in timing and interlock logic make it easy to program
the C2N-SDC for fail-safe operation.
The C2N-SDC mounts in the wall or ceiling using an off-the-shelf 4" square or 2-gang
electrical box. Pushbuttons on the front of the unit allow for manual operation of the
motors during installation and setup.
C2N-SDC-DC
The C2N-SDC-DC is a 2-channel shade and drape controller designed to provide a
convenient and cost-effective solution for controlling 24 volt DC motorized shades and
drapes. The C2N-SDC-DC is a Cresnet device with two independently controlled 24V DC
outputs, each designed to provide standard up/down or open/close control of a
conventional two-wire bidirectional type motor.
The C2N-SDC-DC mounts in the wall or ceiling using an off-the-shelf 4" square or
2-gang electrical box. Pushbuttons on the front of the unit allow for manual operation
of the motors during installation and setup.
C2N-SSC-2
The C2N-SSC-2 Somfy Shade Controller is a compact Cresnet device designed to
provide a bidirectional serial interface for up to two Somfy ILT Intelligent Shade Motors
(http://www.somfy.com/nam/index.cfm). Window treatments equipped with the Somfy
ILT motor offer enhanced capability compared to typical 3-wire models.
In addition to basic open/close commands, the C2N-SSC-2 allows for setting each
shade to a specific position and polling for its current position with 16-bit precision.
Feedback signals provide confirmation of each motor's activity to enable precise,
predictable control, even from a remote location. Limit adjustments are set
electronically using buttons provided on the face of the unit, and up to 20 presets for
each output can be saved onboard the C2N-SSC-2 for easy recall through the control
system. The C2N-SSC-2 mounts discreetly to any flat surface and requires a simple
Cresnet connection to the control system.