Filter
Top Products
Crestron Commercial Lighting Design Guide GreenLight Options–CAEN Enclosures
Doc. 4775A 42
CLX Lighting Control Modules
Concealed in Crestron automation cabinets, the CLX-series devices are rigorously built using oversized heat sinks for
ultimate reliability.
Split-bobbin transformers and ground-referenced electronics deliver
superior performance
Lamp flicker is minimized through the innovative Crestron zero-crossing
detection technique, backed by proprietary firmware
Low-maintenance convection cooling assures quiet and trouble-free
operation
Noise suppression inductors and international 230V versions are
available
LEDs on the modules indicate communication to a Cresnet® network,
input power to the module, and output power to the load
A five-pin ribbon cable interconnects modules and the processor
NOTE: CLX modules and their associated CLT terminal blocks
must be installed into the lowest available spaces and continue
toward the top of the enclosure.
CAUTION: A bypass jumper is provided to allow testing and to
protect the module during installation. When properly secured
by nine screws, the jumper on the black and red section of the
terminal block shorts the LINE in to DIM out so that the circuit
is energized. Do not remove the bypass jumper until all feed
and load wiring has been completed, the circuit has been
tested for electrical faults, and the module has been installed.
Furthermore, the jumper on the white section of the terminal
block ties the neutral in to the neutral outs. This jumper should
never be removed.