Craftsman 139.53993D Garage Door Opener User Manual


 
Using the Wall.Mounted Door Control
THE PREMIUM CONTROL
CONSOLE Lighted
Push Button
Press the lighted push button to open I _ -_-_._
or close the door. Press again to
reverse the door during the closing Light
cycle or to stop the door while it's utton
opening. Lock
Button
Light feature
Press the Light button to turn the opener light on or off. It
will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn
it off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held
remote controls. However, the door will open and close
from the Door Control, the Outdoor Key Switch and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as the
Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing. The
Lock feature will also turn off whenever the "learn" button
on the motor unit panel is activated.
Additional feature when used with the 3-Function
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold
a small remote button that you want
to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights flash, release all buttons.
To Open the Door Manually
Toprevent possible SERIOUSINJURYor DEATHfrom a
falling garagedoor:
If possible, useemergencyreleasehandleto disengage
trolley ONLYwhengarage door is CLOSED.Weakor
broken springs or unbalanceddoor could result in an open
door falling rapidly and/or unexpectedly.
NEVERuseemergency releasehandle unless garage
doorway is clear of persons and obstructions.
NEVERusehandle to pull door open or closed. If ropeknot
becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed if possible. Pull down on
the emergency release
handle (so that the trolley
release arm snaps into a
vertical position) and lift the
door manually.
The lockout feature
prevents the trolley from
reconnecting automatically,
and the door can be raised
and lowered manually as often
as necessary.
o__--Trolley
-- Trolley Release
Arm (in Manual
Disconnect Position)
Lockout position
(Manual disconnect)
TO RE-CONNECT THE
TROLLEY:
Pull the emergency release
handle toward the opener at
an angle so that the trolley
release arm is horiflontal. The
trolley will reconnect on the
next UP or DOWN operation,
either manually or by using the
door control or remote.
Release Handle
(Pull at 45° angle)
To reconnect
31