Filter
Top Products
LOCATE WALL PUSH BUTTON (OR ANY ADDITIONAL PUSH BUTTONS) WHERE GARAGE
DOOR IS VISIBLE, AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF THE REACH
OF CHILDREN.
SERIOUS PERSONAL INJURY FROM A MOVING GARAGE DOOR MAY RESULT FROM MIS-
USE OF THE OPENER° DO NOT ALLOW CHILDREN TO OPERATE WALL PUSH BUTTON(S)
OR THE TRANSMITTER.
FASTEN THE CAUTION LABELON THE WALL NEAR WALL PUSH BUTTON AS A REMINDER
OF SAFE OPERATING PROCEDURES.
PROCEDURE: Remove about a 1/4" of insulation
from each end of the 2-strand bell wire_Connect one
end to the screw terminals on the back of wall control
as shown
Fasten the wall control to an inside garage wall with
the 8ABxl" sheet metal screws provided A con-
venient place is beside the service door and OUT OF
THE REACH OF CHILDREN,
Run the bell wire up the wall and across the ceiling to
garage door opener Use insulated staples to secure
wire,
The receiver terminals and the antenna are located
on the back panel of the opener chassi& Position
antenna wire as shown_ Then connect wire by color
to the white and red opener terminal screws,
Top
installation
Bottom
Installation
Ftange
Wall
Control
Terminals
2_Strand
Bell Wire
Opener
Staples Terminal Screws
Wail Control Back Panel
Push Button of Opener
OPERATION OF THE LIGHTED WALL CONTROL
Press and release to open or dose door
Press and release again to REVERSE door during CLOSING cycle or
to STOP door during OPENING cycle
NOTE: Wait about 1-second between commands.
Antenna
WIRING INSTRUCTIONS FOR ACCESSORIES
Open Door Indicator:.
TOwhite & orange opener terminals
Outdoor Key Switch:
To red & white opener terminals
Touch Code Lock:
TO red and white opener terminals
Infrared Reversing System:
To while & black opener terminals
!3
r_