Filter
Top Products
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
a.
B.
This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not try
to light the burner by hand.
BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
C.
• If you cannot reach your gas supplier, call
the fire department.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• hnmediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
D.
Do not use this appliance if any part has been
under water, hnmediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
.
3.
4.
.
2.
.
OPERATING INSTRUCTIONS
Gas
Inlet --
STOP! Read the safety information above on
this label.
Set the thermostat to lowest setting.
Turn off all electric power to the appliance.
This appliance does not have a pilot. It is
equipped with an ignition device which auto-
matically lights the burner. Do not try to
light the burner by hand.
.F====I
5. Remove front panel.
6. Pull the gas control lever DOWN clockwise -+
to "OFF". Do not force.
7. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you
smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't
smell gas, go to the next step.
8. Push gas control lever UP counterclockwise
to "ON".
9. Replace front panel.
Gas control 10. Turn on all electric power to the appliance.
knob shown 11. Set thermostat to desired setting.
in"OFF" 12. If the appliance will not operate, follow the
position instructions "To Turn Off Gas To Appliance"
and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
Set the thermostat to lowest setting. 4.
Turn off all electric power to the appliance
if service is to be performed. 5.
Remove front panel.
Pull the gas control lever DOWN clockwise -+
to "OFF". Do not force.
Replace front panel.
Page 10