Filter
Top Products
DR
COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions 37
Figure 43
Blower Inlet Hose:
Tools Needed:
Diagonal or wire cutter
Screw driver or nut driver
Inlet
Hose
Adapter
Support Tie,
cut excess here
Blower
Inlet Hose
Clamp
Lanyard
Safety
Interlock
Switch
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
1. Cut the support tie around the
Blower Inlet Hose (Figure 43).
2. Loosen the clamp retaining the
Inlet Hose at the Inlet Hose
A
dapter and the connector fittin
g
at the opposite end of the hose.
T
hen slip the hose off the adapter
and fitting (Figure 43).
3. Install the new hose in the reverse
order making sure that the clamps
are positioned on the blower side
of the raised rivet in the Inlet Hose
A
dapter and on the fitting side o
f
the raised rivet in the connector
fitting to prevent the hose from
slipping off after the clamps are
tightened.
4. Check the Safety Interlock Switch
to be sure that it is engaged.
5. Install a new Support Tie, through
the Lanyard and around the Inle
t
Hose about half way along the
hose (Figure 43). Cut off excess
Support Tie.