Filter
Top Products
28 DR
COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Operating the Chipper
In addition to towing the DR LEAF and LAWN VACUUM with your lawn tractor, and
using it as a vacuum; the system also allows you to chip sticks and limbs up to 2" in
diameter.
1. Start the engine in accordance with “Starting & Stopping” on page 24.
2. To process branches; feed them into the Chipper Hopper opening (Figure 31).
3. As the chipped branch shortens, finish chipping it by pushing the stub down the
Hopper with the next branch to be chipped.
WARNINGS!
Always operate the chipper from the “Chipping Zone” (see
Figure 27
on page 25).
To prevent damage to your chipper, feed only wood up to 2" in diameter into the
Chipper Hopper.
Before performing any maintenance procedure, stop the engine and disconnect
the spark plug wire.
NEVER use your hand to push the remaining wood stub down into the Chipper
Hopper or try to remove a lodged piece of wood with the engine running.
Figure 31
Chipper
Hopper