Filter
Top Products
16 DR
COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Blower Exit Elbow Assembly Installation
The following procedure includes the steps necessary for installing the Blower Exit Elbow
Assembly on the DR LEAF and LAWN VACUUM.
1. Install the Blower Exit Elbow Assembly
on top of the Blower with the elbow
pointing toward the Collector Box
(Figure 14).
2. Align the hood of the Blower Exit
Elbow Assembly to assure that the
Safety Interlock Switch is engaged,
verify the position of the Lanyard as
shown, and then install a Lock Washer
and Flat Washer over each of the four
(4) 5/16" x 1/2" Wing Screws and hand
tighten them to the blower housing
(Figure 14).
Tip: Start all four (4) Wing Screws before
tightening them securely.
Note: If the Safety Interlock Switch is not
engaged, the engine will not start.
Adjust the switch mounting
bracket by loosening the bracket
bolt and sliding the bracket up so
that the button on the switch is
fully depressed against the Blower
Exit Elbow Assembly.
Connecting the Collector Box Inlet Hose to the
Blower Exit Elbow Assembly
The following procedure includes the steps necessary for connecting the Collector Box Inlet
Hose to the Blower Exit Elbow Assembly on the DR LEAF and LAWN VACUUM.
1. Connect the hose from the
Collector Box to the Blower Exit
Elbow Assembly by aligning the
two flexible latches (Figure 15) and
slipping the hoses together.
2. Pull and hook the two flexible
latches into place (Figure 15) to
secure the hoses.
Note: Align the Exit Elbow with the
hose by loosening the two (2)
Wing Screws (Figure 14) one or
two turns and then turn the
Elbow to align with the hose.
Blower Exit Elbow
Pull & Hook
Flexible Latches
Collector
Box Hose
Hook here
Figure 15
Figure 14
Collector
Box Hose
Safety
Interlock
Switch
Blower Exit
Elbow
Assembly
Wing Screw
4 places
Loosen
Bolt to
Adjust
Lanyard
Angle
Adjusting
Wing Screw
2
p
laces