Filter
Top Products
INSTALLATION PRECAUTIONS
The Simpson Dura Vent Direct Vent System and the Selkirk Model Direct-Temp System are engineered
products that have been designed and tested for use with the Country Flame Bayvue DV product. The
chimney pipe product warranty will be voided and serious fire, health, or other safety hazards may result
from any of the following actions:
Installation of any damaged venting component.
Unauthorized modification of the venting system.
Installation of any component part not approved by Country Flame.
Installation other than as instructed by these instructions.
Conform to all local building codes during product installation.
INSTALLER SAFETY PRECAUTIONS
Wear gloves and safety glasses for protection.
Take note of all power lines when using ladders or working on roof tops.
Be aware of electrical wiring locations in walls and ceilings.
Properly use ladders and ensure safe angles for use.
VENTING PARTS LIST
The Simpson Dura Vent Direct Vent System offers a complete line of component parts for installation of
both horizontal and vertical installations. Many items are offered in decorative black, as well as
galvanized finish. The galvanized pipe and fittings are used for concealed locations such as attics, or
spaces where corrosion is a factor, such as above the roof line. Decorative plated trim kits are available for
both wall thimbles and ceiling support boxes. Snorkel terminations are available for applications which
may require vertical rise on the building exterior. The components listed in TABLE 5 have been approved
for use with the Country Flame Bayvue DV Stoves.
Version 1.0h
20
WARNING
Always maintain required clearances (air space) to nearby combustibles to prevent a fire hazard. Do not fill air
space with insulation. Minimum clearance between vent pipes and combustible surfaces is 1 inch (25mm) except
where stated otherwise. Be sure to check the vent termination clearance requirements from decks, window soffits,
gas regulators, air supply inlets, and public walkways, as specified in these installation instructions and local
building codes. (Refer to the drawing for horizontal termination locations).
The gas appliances and vent system must be vented directly to the outside of the building, and never be attached to
a chimney serving a separate solid fuel or gas-burning appliance. This direct vent gas appliance must use its own
separate vent system. Common vent systems are prohibited and void the warranty.