Filter
Top Products
PYROMASTER@ UVHB26 Vent-Free Heaters
INSTAllATION
0 1. PREPARING THE UVHB26
To be sure that each step of the heater installation
is in order, use the check-off boxes provided.
The UVHB26 may only be used with the approved
mantel and hearth assembly.
1. After determining a location, open the mantel
hearth base carton and place into position on a
solid surface. NOTE: Be sure to level the base
before setting the UVHB26 heater in place.
2. Place the heater on the hearth base centering
side to side and 3/4" from the back edge of the
hearth base (See Fig. 1.)
3. Bend the lower mounting tabs down against the
hearth base and secure with two (2) wood
screws (See Fig. 1.)
0 2. INSTALLING BRASS TRIM
1. Remove brass trim (3 pieces) from carton and
remove the protective coating from each piece.
2. Using the provides (2) screws attached the side
pieces to the heater (See Fig.3.)
3. Mount the top trim to the heater and be sure to
overlap top trim to the front side of the side trim
pieces. .
6
v
r;?' '
r;?" ~~ BRASS TRIM
(SIDES)
Fig. 3. Insulating brass trim.
, ,.,5)
.:')
, ,.,5)
FP731
..~.)
)
'