Filter
Top Products
PYROMASTER@ UVHB26 Vent-Free Heaters
D 10. lOG INSTAllATION (refer to fig. 9)
1. Set the back log on the studs attached to the
burner pan.
2. Installthe front log in-between the ember guard
and front lipof the unit.This should be a snug
fit.
3. Set the "Y"log in the notches in the front and
rear logs.
4. Set the right cross log in the right notch of the
front log and the other end on the dimple of the
"Y"log.
5. Set the leftcross log on the dimple of the "Y"
cross log and the opposite end in the groove in
the back of the front log.
D 9. ROCK PLACEMENT
1. lava Rock
The lava rock provided withthis heater must be
placed on the wire screen inthe center of the
burner tube. Place just enough lava rockto cover
the screen. Do not pile the rock.
2. Volcanic rock
h Spread the volcanic rock (gravel size)
..on the burner pan of the fireplace. This
willgive the fireplace a realistic look.
Under no circumstances should this lava rock
be placed on any part of the burner tube.
10
~ NOTCHES FOR "Y"
L L LOG LOCATION
~ oil( REAR LOG
rt
0
NOTCHES
TO LOCATE~ U
LOGS ~ ~~
F q/ ~
:)
DIMPLES TO
LOCATE CROSS
LOGS
FRONT LOG
LEFT LOG ~REARLOG
RIGHT LOG
FRONT LOG
"Y" LOG
FP734
Fig. 9. Log locations.
~"
<~:#
.,~)