Filter
Top Products
PYROMASTER@ UVHB26 Vent-Free Heaters
OPERATING INSTRUCTIONS
FIRST FIRING
Upon completing the gas line connection, a small
amount of air will be trapped in the line. When first
lighting the unit with pilot light, it will take a few
minutes to purge the trapped air. Once purging is
complete, the pilot and burner will light and oper-
ate as indicated in the instruction manual. Subse-
quent lightings of the appliance will not require
purging.
When lit for the first time, the appliance will emit a
slight odor for an hour or two. This is due to paint
and lubricants used in the manufacturing process.
After each lighting, vapor may condense and fog
the glass; this moisture disappears in a few min-
utes of burning.
. SAFETY PRECAUTIONS FOR
STANDING PilOT HEATERS
FOR YOUR SAFETY - READ THIS SECTION
BEFORE LIGHTING!
A
WARNING: IF YOU DO NOT
FOllOW THESE INSTRUCTIONS
EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR lOSS
OF LIFE.
A. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to
floor because some gas is heavier than air and
will settle on the floor.
IF YOU SMELL GAS:
1. Do not try to light any appliance.
2. Do not touch electrical switches; do not
use any phone in your building.
3. Immediately call your gas supplier from a
neighbor's phone. Follow your gas
supplier's instructions.
4. If you cannot reach your gas supplier, call
the fire department.
B. Use only your hand to push in or turn the gas
valve control knob. Never use tools. If the
knob will not push in or turn by hand, don't try to
repair it, call a qualified service technician.
Force or attempted repair may result in a fire
or explosion.
C. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of this control system and
any gas control which has been underwater.
LIGHTING INSTRUCTIONS FOR
HONEYWELL
1. STOP! Read the safety information above.
2. To access the controls, Remove lower louvre.
3. Turn wall switch and wireless remote OFF (if
used).
4. Push in gas control knob slightly and turn
clockwise ~ to OFF. See figure 10.
5. WAIT 5 MINUTES TO CLEAR OUT ANY GAS.
If you then smell gas, STOP! Follow A in the
safety information. If you do not smell gas, go
to next step.
BLACK
JUMPER
~ w>-,,~=
"~ PIEZO IGNITOR
HED
PILOT
FP829
Fig. 10. Honeywell valve and pilot assembly.
11