Filter
Top Products
English-8
1. 20 lb. Refillable Cylinder (purchase separately)
2. Fuel Hose
3. Regulator
Attachment Kit Features
Fig. 22
Connecting 20 lb. Propane
Gas Cylinders
NOTE: Your 9422 Series stove is set up from
the factory to use a 20 lb.refillable propane
cylinder. You may purchase a 20 lb.
propane cylinder from the store where you
bought your stove, or from your local
propane dealer.
WARNING
This procedure MUST be performed
OUTDOORS only! Be sure the LP cylinder
valve is closed. Attach to the stove. Read and
follow the directions on the cylinder.
1. Place the stove on a flat and level surface. Set
up the stove (see Fig.1 through Fig. 6) and
make sure the controls are off (Fig. 23).
Fig. 23
2.
Attach the fuel hose to the regulator
(Fig. 24).
3.The regulator uses a threaded fitting to attach
to the stove. It is necessary to hold the stove to
make sure the fitting is seated. Align the
regulator to the fuel tube on the back of the
stove and push on. Screw on the outer
threaded sleeve in a clockwise direction until
hand tight (Fig. 25).
Fig. 25
1
2
3
Fig. 24
WARNING
During assembly of the stove
and when attaching or
replacing the L.P. gas cylinder,
insure that the gas supply hose
is free of kinks and/or damage
and is at least 3 inches away
from hot surfaces such as the
stove housing.
IMPORTANT!
TO ENSURE PROPER GAS FLOW,
BURNER CONTROL VALVES MUST BE
“OFF”
BEFORE OPENING THE GAS
CYLINDER VALVE
.
CAUTION
In the connection process, the stove side of
the connection will seal on the back-check
in the valve, resulting in a slight resistance.
The connection requires about one-half to
three-quarters additional turn to complete
the connection.To disconnect, turn
counterclockwise.Tighten by hand only.
DO NOT use tools.