Coleman 9422 Series Stove User Manual


 
Fig. 11
Propane cylinder correctly installed (Fig. 10).
Never operate stove with propane cylinder in an
inverted position (Fig. 11).
Fig. 8
Fig. 8
Fig. 10
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection
has been leak tested and does not leak.
Leak Check
WARNING
• BURN HAZARD
• Never leave stove unattended when hot
or in use.
• Keep out of reach of children.
To Light
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can accumu-
late in low places.If you smell gas, leave the
area immediately.
• Always attach or detach propane source out-
doors; never while stove is lighted, near flame,
pilot lights, other ignition sources or while
stove is hot to touch.
• This stove is red hot during use and can ignite
flammables too close to the burners. Keep
flammables at least 12 inches from the sides
and 48 inches from the top of the stove. Keep
gasoline and other flammable liquids and
vapors well away from stove.
• The stove must not be exposed to flammable
vapors or liquids during lighting.
Fig. 6
Control Knob Identification (Fig.6)
Right
Burner
Valve
Igniter
Button
Left Burner Valve
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and stove propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
Close both burner valves firmly (Fig. 7).
Fig. 7
The regulator uses a threaded fitting to attach to
the stove. It is necessary to hold the stove to
make sure the fitting is seated. Align the regula-
tor to the fuel tube on the back of the stove and
push on. Screw on the outer threaded sleeve in
a clockwise direction until hand tight (Fig. 8).
Remove plastic cap from top of propane bottle
and screw propane bottle into regulator hand
tight (Fig. 9).
Fig. 5
English-4
Note:
The food prep side may be removed from the
stove. Firmly grasp the food prep, raise slightly, and
slide back to dis-engage the hinges. Reverse the
procedure to reattach the food prep side (Fig.5).