Filter
Top Products
English-11
CAUTION
Be certain the gas is shut off at the
L.P. cylinder valve anytime the stove
is not in use.
Follow These Steps:
1.
Shut off the gas at the burner valve(s) and
stay away!
2.
Allow the fire to burn itself out.
3.
Once the fire is out and the appliance has
cooled, shut off the L.P.cylinder valve.
4.
Clean all parts and inspect for damage.
Parts to check for damage are the L.P.
cylinder, cylinder valve, regulator, gas
supply hose, burner valve(s) and burner(s).
5.
If any of the above mentioned components
are damaged, seek replacement from
Coleman before operating the stove again.
Locate your nearest service center by
calling
1-800-835-3278.
In Case of Grease Fire
Moving and Storage
Steps to follow before storing the stove:
• For outdoor use only. If the stove is stored
indoors, detach and leave the refillable cylinder
outdoors. If left outdoors, turn off the fuel supply
to the L.P.cylinder and cover the stove for
protection from the weather. The accessory
section of this manual lists a stove carry case
suitable for storage and carrying the stove.
WARNING
If the stove is not in use, the gas MUST be
turned off at the fuel supply cylinder.
Place the dust cap on the cylinder valve
outlet whenever the cylinder is not is use.
Only install the type of dust cap on the
cylinder valve outlet that is provided with
the cylinder valve. Other types of caps or
plugs may result in leakage of propane.
Troubleshooting
Problem: Stove will not light
when the igniter button is
pushed or has incomplete burner
flame.
Possible Causes and Solutions:
1. Lack of fuel. Check to see that the cylinder
valve is open and the cylinder has fuel.
2. Burner ports, orifices, valves or hose have
blockage. Clean the components.
3. Crimped fuel supply hose needs
straightened.
NOTE: The following
“Troubleshooting Causes and
Solutions” are specific to issues
related to a stove setup with a 20
lb. refillable propane cylinder.
4. Regulator failure or damaged hose need to
be replaced by an authorized service
dealer.
5. Make sure the hose to the cylinder is properly
assembled. See the section titled “Connecting
20 lb.Propane Gas Cylinders”.
6. The “Flow Limiting Device” may have been
activated. Refer to the special instructions
in the next section “For Your Additional
Safety”.
Problem:Yellow flame.
Possible Causes and Solutions:
1. Air may be in the cylinder if the cylinder
was not properly purged. Use up
remaining gas; the yellow flame may
disappear with use.
Problem: Flame blows out on low
setting or has uneven heat distri-
bution.
Possible Causes and Solutions:
1. Lack of fuel. Check to see that the cylinder
valve is open and that the cylinder has
fuel.
2. The “Flow Limiting Device”may have been
activated. Refer to the special instructions in
the next section “For Your Additional Safety”.
Problem: Fire at any connection.
Possible Causes and Solutions:
IMMEDIATELY shut off cylinder valve and
allow stove to cool.
1. Gas is leaking from a faulty connection.
Tighten connections with an adjustable
wrench and replace damaged parts.
Perform a leak test on all connections
before cooking on the stove again.
Problem: Flame behind control
panel or control knob area.
Possible Causes and Solutions:
IMMEDIATELY shut off cylinder valve and
allow the stove to cool.
1. Gas is leaking from a faulty connection.
Tighten connections with an adjustable
wrench and replace damaged parts.
Perform a leak test on all connections
before cooking on the stove again.