Cisco Systems WVC80N Home Security System User Manual


 
Chapter 3
Advanced Configuration with the Web-based Utility
19
Wireless-N Internet Home Monitoring Camera
Audio Port To change the Audio Port, enter the new
port number (even values only, from 1024 to 65534) in
the field provided. The default Audio Port, 2242, can be
used for multicasting and does not normally need to be
reconfigured. If this port number needs to be changed,
contact your network administrator.
Time to Live Enter the maximum length of time (usually
measured as the number of network routers that can
be passed before the data arrives at its destination or is
dropped) within which the data must reach its destination.
The value must be from 1 to 255. The default value is 16.
To save your changes, click Apply. To cancel any unsaved
changes, click Cancel. To get additional information about
the screen’s features, click Help.
Setup > Motion Detection
The Setup > Motion Detection screen allows you to
configure the Camera’s motion detection settings.
Setup > Motion Detection
Trigger Motion Detection
Enable Motion Detection Check this box to enable
Motion Detection.
Attachment Type Select the type of attachment to be
sent, either JPEG or Video. If JPEG is selected, a series of
images will be attached to the e-mail as individual files. If
Video is selected, a single video file will be attached.
Frame Rate If the Attachment Type field is set to JPEG,
select the frame rate (number of frames to be captured
per second), from 1 to 5. The default value is 1.
Video Format If the Attachment Type is set to Video,
select the video format, either ASF, MPEG-4, or 3GP.
Pre-Capture Length This refers to video footage up to
the moment when motion is detected. Select how many
seconds’ worth of this video will be saved. This value must
be between 0 and 4 seconds.
Post-Capture Length Select how many seconds’ worth
of video will be saved starting from the moment motion
is detected. This value must be between 1 and 5 seconds.
Interval Enter the time in minutes that must pass
between motion detection events. Valid values are 0-5,
10, or 15. The default is 2. A value of 0 indicates no delay
between events.
Action(s) Select the action(s) to be performed upon
motion detection. Select E-Mail to send an e-mail with a
video attachment to a selected recipient., or select FTP to
send the video to a selected FTP server.
E-Mail Alert
If the Action(s) field is set to E-Mail, fill in the following
fields:
Send To Enter the e-mail address where e-mail will be
sent upon motion detection. You can optionally specify
up to three addresses.
Show “From” as Enter the e-mail address to be used as
the From field in the e-mail to be sent.
Subject Enter the Subject field for the e-mail, consisting
of 48 alphanumeric characters or less.
SMTP Port Number Enter the SMTP port number from 1
to 65535. The default is 25.
SMTP Mail Server If you want to use an SMTP mail server,
check the box next to Specify a SMTP Mail Server. Then
enter the mail server’s name in the field provided.
My Mail Server Requires Authentication If you are using
an SMTP mail server that requires authentication (you
must log in with a username and password), check this
box, then fill in the Account Name and Password fields.
Test E-Mail Click this button to send a test e-mail to the
address indicated by the Send To field.
FTP
If the Action(s) field is set to FTP, fill in the following fields:
FTP Server Enter the FTP server name.
Port Enter the FTP server’s port number.
Login Name and Password Enter the login name and
password for the account on the FTP server.
Passive Mode Select Enable (default) to enable passive
mode, or Disable to disable it.
File Path Name Enter the path to the location where the
file will be saved on the FTP server.