Filter
Top Products
8
Install the pulley
3
HARDWARE
H3
Bolt
H2
Bolt 1/4"-20x1-3/4"
H4
Lock Nut 1/4"-20
H6
Nut 3/8"
H7
Lock Washer 3/8"
3.1 Lay the belt beside the rail, as shown.
Grasp the end with the hooked trolley
connector and pass approximately 12"
(30 cm) of belt through the window.
Keep the ribbed side toward the rail,
and allow it to hang.
3.2 Remove the tape from the pulley. The
center should be greased, if not, re-
grease the center of the pulley.
3.3 Insert the pulley into the window of the
front rail.
3.4 Insert the bolt (H3) into the rail and
pulley. Tighten securely with the lock
washer (H7) and nut (H6).
3.5 Rotate the pulley to be sure it spins
freely.
3.6 Insert the bolt (H2) into the hole
shown and fasten with the lock
nut (H4).
H6
H7
H4
Screwdriver
Rail
Pulley
Trolley
Connector
H2
H3
Assembly