Filter
Top Products
LIG
H
T
LIGHT
LO
C
K
L
IGH
T
LOCK
LIGHT
LOCK
LIGHT
LOCK
LIGHT
PROGRAMMING
NOTICE: If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in the
receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the
copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to
circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door
will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
®
remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON TO ADD ADDITIONAL REMOTE CONTROLS USING
MOTION DETECTING DOOR CONTROL
LOCK
LOCK
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
Memory
1. Press and hold the button on the
hand-held remote
* that you wish to
operate your garage door.
2. While holding the remote control
button, press and hold the LIGHT
button on the Motion Detecting
Control Panel.
3. Continue holding the remote control
and LIGHT buttons while you press
the push bar on the Motion Detecting
Control Panel (all three buttons are
held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
*3-Button Remote
If provided with your garage door opener, the large button
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6-9 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
is factory programmed to operate it. Additional buttons on
any Security✚
®
3-Button remote or
mini-remote can be
programmed to operate
other Security✚
®
garage door openers.
26