Filter
Top Products
WARNING
WARNING
IMPORTANT SAFETY INSTRUCTIONS
WARNINGWARNING
To reduce the risk of SEVERE INJURY or DEATH:
1. This portable luminaire has a polarized plug (one blade is
wider than the other) as a feature to reduce the risk of
electric shock.
2. This plug will fit in a polarized outlet ONLY one way.
3. If the plug does not fit fully in the outlet, reverse the plug.
4. If it still does not fit, contact a qualified electrician.
INSTALLATION STEP 6
Install Remote Light
The remote light is designed to plug directly into a
standard 120V outlet.
1. Install the hinge and latch clips. Clips slide in between
the metal plate and the plastic housing on each side of
the light base (Figure 1).
2. Select an appropriate location on the ceiling to mount
the light within 6' (1.8 m) of an electrical outlet so that
the cord and light are away from moving parts.
3. Install the ceiling mount plate with the screws
provided. Leave 1/8" (3.1 mm) of the thread exposed
between the ceiling and the screw head (Figure 2).
NOTE: If installing remote light on drywall and a ceiling
joist can not be located, use wall anchors provided. No
pilot hole is required for wall anchors.
4. Determine the length of power cord needed to reach
the nearest outlet. Wind any excess cord around cord
retainer on the top side of the light base.
5. Install the light base by pushing onto the screws and
turning the base clockwise to lock the light in place.
6. Install two Type A19 incandescent or compact
fluorescent bulbs. 100 watt maximum per bulb,
200 watts total.
7. Install the light lens by hooking one end of the lens
over the hinge and pressing up on the other end to
latch into place (Figure 3).
8. Plug in the light to outlet.
NOTE: Light will not operate until the unit is activated.
Use A19, standard neck garage door opener bulbs for
replacement.
HARDWARE SHOWN ACTUAL SIZE
Light Clip Screw
Screw #6x1" (2)
#4-20 X 7/16" (2)
Wall Anchor (2)
5. NEVER use with an extension cord unless plug can be fully
inserted.
6. Do not alter the plug.
7. Light is intended for ceiling mount and indoor applications
ONLY.
To prevent possible OVERHEATING of the endpanel or light
socket:
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.
Figure 1
Light Clip Screw
Latch Clip
Light
Base
Plastic
Metal
Hinge Clip
Housing
Light Clip
Plate
Screw
Figure 2
Wall Anchors
Cord
Retainer
Scews
Figure 3
100 Watt (max)
Light
Lens
11