Filter
Top Products
LOCK
LIGHT
Using the Wall-Mounted Door Control
Additional feature when used with the 3-Button
THE MOTION DETECTING DOOR CONTROL
Press the push bar to open or
Push
close the door. Press again to
Bar
reverse the door during the
closing cycle or to stop the door
while it's opening.
Detector
This door control contains a
Switch
motion detector that will
automatically turn on the light
when it detects a person entering
Lock
Light
Button
the garage. This feature can be
Button
easily turned off for extended
work light use.
Light feature
Press the Light button to turn the opener light on or off. It
will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn
it off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor See
Automatic Light Feature, following.
Automatic Light Feature: The opener light will turn on
automatically when a person enters the garage. When
a person walks in front of the door control, the light will
come on for five minutes, then shut off. This feature
works by detecting body heat and may not work in
temperatures around 100˚F (37.7˚C).
To disable this feature, slide the Detector Switch on the
right side of the door control down (off).
We recommend that you disable the motion sensor
when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensor’s range.
Lock feature
Designed to prevent operation of the door from hand-held
remote controls. However, the door will open and close
from the Door Control, the Outside Keylock and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push bar light will flash as long as the Lock
feature is on.
To turn off, press and hold the Lock button again for
2 seconds.The push bar light will stop flashing. The Lock
feature will also turn off whenever the “Learn” button on
the motor unit panel is activated.
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold a small remote
button that you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights flash, release all buttons.
22