Filter
Top Products
23
DVRTSB Bay Window Fireplace
10003848
LG299
Ceramic Ember Rock Location
Fig. 40 Location of log cradle prongs in relation to assembled logs.
Your log set contains two types of
“Lava Rocks”.
The placement of this material is
best done after the logs have been
installed.
Ceramic Ember Rocks (Pt. # 57897)
Remove these ‘rocks’ from the
packaging and spread them over the
burner tiles in a random fashion to
fill up the spaces between the logs.
(Fig. 40) Only place ceramic embers
in areas shown in Figure 40.
Lava Rock (Pt.# 10001454)
Remove this material from the
packaging and spread it over the
ceramic floor panels outside the
log stack. DO NOT PLACE THIS
MATERIAL ON THE BURNER TILES.
Lava Rock & Ember Material
Flame & Temperature Adjustment
RN/RP Models
For units equipped with ‘HI/LO’ valves the flame
adjustment is accomplished by rotating the ‘HI/LO’
adjustments knob located near the center of the gas
control valve. (Figs. 41 & 42)
Turn
counterclockwise
to decrease
flame height
Turn clockwise
to increase
flame height
HV102
Honeywell hi/lo knob
4/5/99 djt
Fig. 41 Flame adjustment knob for Honeywell valve.
It is important to periodically perform a visual check of
the pilot and burner flames. Compare to the illustrations
below. (Figs. 43 & 44) If the flame patterns appear
abnormal contact a qualified service provider for service
and adjustment.
Flame Characteristics
FP1394
pilot flame combo
3/8" - 1/2"
SIT Pilot
PSE Pilot
FP1394
Fig. 43 Correct pilot flame appearance.
LG300
DVRTSB log flames
7/03
LG300
Fig. 44 Correct burner flame appearance.
L
O
H
I
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
Fig. 42 Flame adjustment knob for SIT valve.