Filter
Top Products
26
DV360/580 Series Direct Vent Gas Fireplace
20010667
2. Place the log overlay. Hold
the overlay with the flat side
down and large cut out for
the middle flame on the right.
Set the overlay on top of the
burner toward the left front
inside the stop bracket on
the left end and the bend on
the front left of the burner.
(Fig. 49) A slight adjustment
may be needed after placing
the front right log. (Fig. 51)
LG461
Log
Overlay
Figure 51
3. Place the log front right. Hold the
log with the pointed end toward
the left. Place on top of burner
toward the right. Slide the log
toward the front until it comes in
contact with the bracket at the
front of the burner housing behind
the burner tube. (Fig. 49) Adjust
the log until the pointed end on the
left is aligned with the left edge of
the bracket. Rotate the right end
of the overlay clockwise until it
makes contact with the back of the
log front right. (Fig. 52)
4. Place the glowing embers by
building them up lightly between
the fettle and the burner tube as-
sembly. (Fig. 53)
5. Place the log front left. Set the
log by matching the square hole
on the bottom with the pins on
the overlay. The right side of this
log should come in contact with
the left andiron. Lay the log at an
angle to the left over the fettle.
When this log is in place, it must
not cover the front left opening of
the overlay. (Fig. 54)
Log Front
Right
Front Brackets
LG462
Figure 52
Glowing Embers
LG463
Figure 53
Locator Pins