Filter
Top Products
25
DV360/580 Series Direct Vent Gas Fireplace
20010667
Log Rear
LG960
Stop Bracket
Pilot Notch
Figure 50
H100a
hearth Panels
1/27/00 djt
Screw
Burner
Hearth Panels
Grate
Front of Unit
H100a
Screw
Fig. 48 Hearth panel location.
Installation of Logs
Remove front glass. (Refer to “Window Frame As-
sembly Removal” Section, Fig. 47) Remove logs from
packaging.
As with all plastics — these are not toys
and should be kept away from children
and infants.
Log Identification Chart
Logs DV360 DV580
Log Front Left 20010673 E9
Log Front Right 20010672 E10
Log Rear 20010675 E8
Log Top Left -- E12
Log Top Right 20010676 E13
Log Front Center -- E11
Log Top Center 20010677 --
Log Overlay 20010674 --
DV360
Stop
Bracket
Rear Log Bracket
Pilot
Bracket
Bend
Front Left
Bend
Front Brackets
FP1607
Fig. 49 Burner brackets and bends.
Left Edge
of Bracket
NOTE: Refer to Figure 49 for bracket and bend loca-
tions.
1. Place log rear. The rear log sits in the firebox at an
angle toward the left over the rear log bracket and
the left side of the burner. (Fig. 49) Set the log on the
rear log bracket. The notch on the right side will go
over the pilot. Swing the left end of the log toward
the front until it makes contact with the stop bracket.
Slide the log to the right so the pilot notch on the
log makes contact with bend on the left of the pilot
bracket. (Fig. 50)