Filter
Top Products
6
4743040 AT0907
CANOPY HARDWARE
Step 4. Attach the canopy to the crossbar mounting
bracket with three of the 8-32 x 2-¼" long canopy screws
and lock washers provided with your Casablanca fan.
Hand tighten until snug against the ceiling.
NOTE: On sloped ceilings, align the canopy opening
toward the top or peak of the room.
CANOPY HARDWARE (not to scale)
Canopy
Canopy Hatch
Canopy Lock Washer (5)
Feed outlet box
wires through
canopy opening
HANGING THE FAN
Step 5. To hang the fan body in the
canopy, hold the fan body fi rmly and
insert the ball into the canopy opening.
Check that no wires were pinched. Rotate
the fan body until the slot in the nylon
ball fi ts into the pin opposite the canopy
opening.
NOTE: Independent control of the
light fi xture using a W-81 requires an
additional power wire run from the
wall switch to the fan. See Page 7 for
wiring.
Ball
Slot
Pin
Canopy Lock
Washer
Canopy
Screws
CANOPY INSTALLATION
Canopy Screw (5)
Capped blue
D1-Option wire
on 4-speed only
for independent
W-81 light
control