Filter
Top Products
5
ESTRADA
™
4743040 AT0907
LAG SCREW INSTALLATION (OPTIONAL)
PERMA•LOCK™ HARDWARE
FAN PREPARATION
NOTE: This step is required only under two conditions:
If the fan weighs 36 lbs. or more (which does not pertain
to this fan) or if the existing ceiling fi xture outlet box
needs to be modifi ed for a ceiling fan application (for
example, if the house is not new construction and you are
replacing an existing light fi xture). We recommend that
the ceiling box be of suffi cient capacity to support the
weight of the fan and light fi xture under any conditions.
If in doubt whether you need to install the lag screw,
consult a qualifi ed electrician.
Step 2 (optional). With the large washer attached, pass the
lag screw (Pack A) through the center hole of the crossbar
mounting bracket and screw into the guide hole. Tighten
until the outlet box is mounted fi rmly to the beam. This
box must be secured to the ceiling fi rmly.
Prepare for fan installation as follows:
Step 3a. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
TIP: The downrod has a tapered thread that is designed
to lock completely when correctly installed.
Step 3b. Using the provided allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning. This will take at least four and a half full turns.
Step 3c. Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION:
Before trimming wires or installing the downrod, pull
the wires on the bottom of the fan to assure they are
all the same length as shown.
Important safety information!
Before starting the installation of your ceiling fan, install the threaded
downrod into the motor coupling and lock the assembly.
CAUTION:
Failure to fully lock in the downrod before securely
tightening the set screw may cause the fan to separate
from the downrod during normal operation!
Large Washer
Lag Screw
Allen Set Screw
¼-20 x ¼"
(Pre-installed)
3 mm
Allen Wrench
Downrod & Ball
Assembly
Motor
Wires
Ground
Wire
Downrod
& Ball
Assembly
Motor
Coupling
Tapered
Thread
Allen Set
Screw