Filter
Top Products
4
4743040 AT0907
GETTING STARTED
FAN INSTALLATION
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit
breaker or fuse box), lower the old fi xture and disconnect
the wiring. Check the ceiling fi xture outlet box to be sure
it is marked “Approved for Ceiling Fan Mounting.” If it is
not, a new box must be installed.
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fi xture located where you
wish to place your Casablanca fan, an approved ceiling
fi xture outlet box must be installed and wired.
NOTE: The weight of this fan is 25 pounds.
WAR NING!
To reduce the risk of fi re, electrical shock, or
personal injury, mount to outlet box marked
“Acceptable Fan Support of 22.7 kg (50 lbs.) or
less” using the mounting hardware provided with
the outlet box.
Step 1a. Remove the knockout plug in the center of the
outlet box or drill a ½" hole for the lag screw to pass
through. Then drill a ¼" guide hole into the joist or beam
to a depth of 3 inches.
Step 1b. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach
the crossbar mounting bracket to the outlet box with the
screws provided, making sure the outlet box wires are not
pinched by the washer.
CROSSBAR MOUNTING BRACKET INSTALLATION
CAUTION:
To reduce the risk of personal injury, use only the
mounting hardware provided with the approved
outlet box to install the crossbar mounting
bracket.
CEILING HARDWARE (not to scale)
Crossbar Mounting Bracket
Ceiling Fan
Approved
Wiring Box
Ceiling Wiring
Ridge Side
Down
Green
Ground Wire
Outlet Box
Mounting
Hardware
Crossbar
Mounting
Bracket
Washer
NOTE: After removing the old fi xture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2 x 4 stud must be installed.
WAR NING!
Support directly to building structure only.
Wire Nut (4)