Filter
Top Products
10
4743040 AT0907
3-SPEED • OPERATION
Pull-chain switches on the fan control the fan and reverse.
Using the fan control pull-chain switch: Fan off at start.
First pull: fan ON, low speed
Second pull: medium speed
Third pull: high speed
Fourth pull: fan OFF
Direction of blade rotation is controlled by the reverse
pull-chain on the side of the switch housing. No changes
in household wiring are required.
3-SPEED • OPTIONAL LIGHT FIXTURE INSTALLATION
NOTE: If a separate circuit is used to control the lights from a
wall control, the BLUE D1-Option wire in the canopy should be
connected to that switch leg with the BLACK fan power wire.
1. Refer to light kit instructions to assemble and attach your
light kit correctly.
2. Remove the two 8-32 screws from the switch housing cap.
3. Remove the plug from switch housing.
4. Install pull-chain switch and finger tighten collar on
switch.
5. Connect one wire from pull-chain switch to the BLUE D1-
Option wire. Secure splice with a wire nut.
6. Connect other wire from pull-chain switch to BLACK wire
from light kit. Secure splice with a wire nut.
7. Connect WHITE wire from switch housing to WHITE wire
from the light kit. Secure splice with a wire nut.
8. At the canopy, connect the BLACK and BLUE wires.
Light
Fixture
Switch
Housing
Blue D-1
Option
Wire
Collar
PERFORMANCE AND ENERGY INFORMATION
Fan Speed
Airfl ow
(CFM)*
Power Use
(watts)
Airfl ow Effi ciency (CFM/
watt)
Low 1864 10 185
Med 4117 33 125
High 7126 82 87
* Measured according to the ENERGY STAR
®
-approved Solid State test method.
Ceiling fan airfl ow is measured in cubic feet per minute (CFM). Power use is measured in
watts. To maximize energy savings,
• Choose a fan with high airfl ow effi ciency (CFM/watt).
• Use ENERGY STAR
®
-labeled lighting in your fan.
• Remember to switch off your fan when you leave the room.
Reverse
Pull-chain
Fan & Speed
Control Pull-chain
Switch
Optional Light
Pull-chain Switch
Remove Plug