Filter
Top Products
12
Stop winding process when 9
bobbin is full. Take the foot off foot
controller.
Manually move bobbin winding 0
clutch back to original position.
While holding the end of the thread, 7
step on the foot controller for a few
seconds. Once enough thread has
wound itself around the bobbin
to hold itself in place, release the
foot controller and trim the excess
thread.
Cut thread and remove bobbin.A
Start winding the bobbin again by 8
pressing down on the foot controller.
�
Place the thread end so that it does
not protrude from the bobbin.
Bobbin Winding Clutch
Controller
Pedal
Press down
�
Pressing down on the controller
harder increases the winding speed.