Filter
Top Products
Winding/Installing the Bobbin 23
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
6
Pass the thread through the slot as shown, and
then pull the thread out toward the front.
1 Cutter
X The cutter cuts the thread.
7
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
X The lower threading is finished.
Next, thread the upper thread. Continue with
the procedure in “Upper Threading” (on the
next page).
Memo
● You can begin sewing without pulling up
the bobbin thread. If you wish to pull up the
bobbin thread before starting to sew, pull
up the thread according to the procedure in
“Pulling up the bobbin thread” (page 35).
1
2
1
S3_brotherE.book Page 23 Thursday, May 15, 2003 1:58 PM