Filter
Top Products
49
2
e
After reaching the end of the stitching, press
the reverse/reinforcement stitch button once.
a Reverse/reinforcement stitch button
• This step is not necessary if a stitch such as
those for sewing buttonholes and bar tacks is
selected where reinforcement stitches are
automatically sewn.
X After reverse/reinforcement stitches are
sewn, the sewing machine stops.
Memo
● Reverse/reinforcement stitches WILL NOT
be sewn until (reverse/reinforcement
stitch button) is pressed. (start/stop
button) may be pressed to stop stitching
when needed such as for pivoting corners.
Adjusting the thread tension
The tensions of the upper thread and of the bobbin
thread (thread tension) should be adjusted so that
they are equal.
If the thread and needle combination is correct for
the type of fabric being sewn (according to “Needle
types and their uses” (page 30)), the thread tension
will automatically be adjusted to the appropriate
setting. However, if the preset thread tension does
not give the desired result or if you are sewing with
special thread or on special fabric, use the thread
tension dial to increase or decrease the tension of the
upper thread.
Note
● If the upper thread is not threaded correctly
or the bobbin is not installed correctly, it
may not be possible to set the correct thread
tension. If the correct thread tension cannot
be achieved, rethread the upper thread and
insert the bobbin correctly.
■ Correct thread tension
The upper thread and the bobbin thread should
cross near the center of the fabric. Only the upper
thread should be visible from the right side of the
fabric, and only the bobbin thread should be
visible from the wrong side of the fabric.
■ Upper thread is too tight
If the bobbin thread is visible from the right side
of the fabric, the upper thread is too tight.
Turn the thread tension dial to the left to
loosen the upper thread.
■ Upper thread is too loose
If the upper thread is visible from the wrong side
of the fabric, the upper thread is too loose.
Turn the thread tension dial to the right to
tighten the upper thread.
a
b
c
d
a Wrong side of
fabric
b Right side of fabric
c Upper thread
d Bobbin thread
a
b
c
e
d
a Wrong side of
fabric
b Right side of fabric
c Upper thread
d Bobbin thread
e The bobbin thread
is visible from the
right side of the
fabric.
a
b
c
e
d
a Wrong side of
fabric
b Right side of fabric
c Upper thread
d Bobbin thread
e The upper thread is
visible from the
wrong side of the
fabric.