Filter
Top Products
27
1
d
Insert the extra spool pin onto the end of the
bobbin winder shaft.
e
Install the thread spool and thread the upper
thread.
Memo
● When setting the thread spool, set it so that
the thread winds off from the front of the
spool.
f
Thread the upper thread for the right side in
the same way that the upper thread for the
left side was threaded.
a Thread guide cover
• For details, refer to step a through j of
“Threading the upper thread” (page 20).
g
Without passing the thread through the
needle bar thread guide, manually thread the
right needle.
Pass the thread through the eye of the needle
from the front to the back.
h
Attach zigzag foot “J”.
• For details on changing the presser foot, refer
to “Replacing the presser foot” (page 33).
i
Turn on the sewing machine.
X The LCD comes on.
j
Select a stitch.
• For details on selecting a stitch, refer to
“Selecting a stitch” (page 42).
• For details on the stitches that can be sewn
with the twin needle, refer to “Stitch
Settings” (page 89).
k
Press (Needle mode selection key).
X The twin needle can now be used.
• To return to single needle sewing, press
(Needle mode selection key).
• Even after the sewing machine is turned off,
the twin needle setting is not cancelled.
a Bobbin winder shaft
b Extra spool pin
c Thread spool
1
● When using the twin needle, be sure to attach
zigzag foot “J”, otherwise the needle may
break or the machine may be damaged.
● After adjusting the stitch width, slowly turn
the handwheel toward you
(counterclockwise) and check that the needle
does not touch the presser foot. If the needle
hits the presser foot, the needle may bend or
break.
● When using the twin needle, be sure to select
the twin needle setting, otherwise the needle
may break or the machine may be damaged.
CAUTION
CAUTION
CAUTION