Filter
Top Products
GETTING READY —————————————————————————————————————————————————————————————————————————————————————————————————————
——
36
c
Lower the presser foot lever, insert the presser
foot holder screw, and then tighten the screw
with the screwdriver.
a Presser foot holder screw
Note
● When sewing with the walking foot, sew at
a speed between slow and medium.
■ Removing the walking foot
a
Press (needle position button) once or
twice to raise the needle.
a Needle position button
X The needle is raised.
b
Turn off the sewing machine.
c
Raise the presser foot lever.
a Presser foot lever
X The presser foot is raised.
d
With a screwdriver, loosen the presser foot
holder screw, and then remove the walking
foot.
a Presser foot holder screw
e
Attach the presser foot holder.
• For details, refer to “Removing the presser
foot holder” (page 34).
Memo
● Only the straight stitch (with reinforcement
stitching) and the zigzag stitch can be used
with the walking foot. For details on the
stitches, refer to “Stitch Settings” (page 89).
● The optional walking foot is available
through your Brother dealer.
● Be sure to securely tighten the screw with the
screwdriver, otherwise the needle may touch
the presser foot, causing it to bend or break.
● Before starting to sew, slowly turn the
handwheel toward you (counterclockwise)
and check that the needle does not touch the
presser foot. If the needle hits the presser
foot, the needle may bend or break.
a
CAUTION
a
a