Filter
Top Products
14.NOTES ON THE PROCESSING AND PRODUCTION OF PLATE BLANKS
BAS-341F, 342F
53
14. NOTES ON THE PROCESSING AND
PRODUCTION OF PLATE BLANKS
* Chamfer other corners of the reverse side of the plate blank with a thickness of C0.3 or thicker, and finish the corners
with fine sand paper.
Please carry out the following points to chamfer the reverse side of the plate blank when using the plate blank for any
supplementary processing of material.
Plate blank
After processing
1968S
*Cross-section A-A’
Use fine sand paper
or similar material
to acquire a smooth
surface for this section.
Point at which to use
sand paper, etc.
1969S 1970S
Plate blank
After processing