Filter
Top Products
6. USING THE OPERATION PANEL
BAS-341F, 342F
20
6-4. Using the TEST switch (Checking the sewing pattern)
Use the TEST switch to begin sewing again from any desired point when the thread breaks or the bobbin thread runs out.
1. Press the TEST switch (15). The indicator (16) will
light.
2. If the work clamp is raised, depress the work clamp
lifter pedal (2) to lower the work clamp.
3. Press the starting pedal (1).
Note
After the feed mechanism has returned to the
home position, it will then move the sewing start
position and the program number will stop
flashing.
This only occurs the first time that a program is
selected.
4. Press the starting pedal (1). (The needle will remain
stationary as the work clamp advances through the
pattern at low speed one stitch at a time. Press the
presser lifter pedal (2) to fast forward.
• If the STEP BACK switch (17) is pressed while moving
at low speed when memory switch No. 20 is ON, the
work clamp will move in the forward direction in steps
of 100 stitches.
5. When the work clamp reaches the desired position,
press the TEST switch (15). The work clamp will stop,
and the test indicator (16) will go out. If the work clamp
was stopped too early, press theTEST switch (15)
again to proceed.
• If the work clamp was stopped too late, press the
STEP BACK switch (17) to advance the work clamp
one stitch at a time.
Resuming operation from a stopping poing
6. Sewing will start when the starting pedal (1) is
pressed.
(
15
)
(16)
1942S
1217S
1215S
(17)