Filter
Top Products
OPERATION
12
Stopping the Water Pump
1. Press stop switch to “Stop” position until engine
stops (Figure 17).
Drain and Flush Water Pump
1. Disconnect and drain suction and discharge
hoses.
2. Remove drain plug at bottom of pump (Figure 18).
3. Remove plug from top of pump and flush internal
components of pump with clean water (Figure 19).
4. Replace both plugs and finger tighten.
Figure 18 — Remove Drain Plug
Figure 19 — Remove Plug from Top of Pump and Flush
Figure 17 — Stop Switch
• DO NOT stop engine by moving choke lever to “Full
Choke” position.
Backfire, fire or engine damage could occur.
CAUTION