Filter
Top Products
TTW1 Universal Service
Replacement Blower
MITW -10 Series
Page 8
Step 8. Instructions to remove power cord from
new universal blower:
a.) Unscrew the (3) Philips head screws
on the blower access cover and
remove the cover. Keep the cover and
screws for future use.
b.) Inside the access compartment, follow
the black wire from the power cord until
you reach the flag terminal attached to
the end of the wire. Disconnect black
wire from the back of the power inlet
connector.
Loosen all (3) screws
holding cover on.
Remove black
wire’s flag terminal
Power cord
Black wire
Power inlet
connector
Blower access cover
(covers access compartment)
Step 7. Install the flue restrictor, P/N
239-47191-00, firmly on the flue. It may
be necessary to lightly tap down the flue
restrictor. Be sure to tap it evenly and
straight down. Wire brush the top of the
water heater if rust or corrosion exists.
Place flue
restrictor on flue.
Warning: Failure to install flue restrictor will result in
improper water heater operation.
Power inlet
connector
Warning: Do NOT remove Torx head screws from
universal blower.