Filter
Top Products
TTW1 Universal Service
Replacement Blower
MITW -12 / -15 Series
Page 12
Step 1. On the water heater’s gas control, turn the
power switch to the “Off” position.
Step 2. Unplug the water heater from wall outlet.
Step 3. Disconnect the vent pipe and adapter that
are connected to the outlet of the blower.
Remove power
cord from
outlet.
Unscrew both clamps that
hold the adapter to the
blower and vent pipe.
Turn switch on gas
valve to “Off” position.
Note: This set of instructions is for the following model numbers: MITW40L*EN12,
MITW40L*BN12, MITW40L*CX12, MITW50L*EN12, MITW50L*BN12,MITW50L*CX12,
MITW40L*EN15, MITW40L*BN15, MITW40L*CX15, MITW50L*EN15,
MITW50L*BN15, and MITW50L*CX15.
Note: The following parts are required to convert the model numbers
shown above: Template, Flue Restrictor, Screws, Wire Harness
MITW-12/15 Series, Universal Blower, Transformer, Junction
Box & its Cover, Wire Nuts, and 2" Exhaust Adapter / Vent
Terminal Kit. Please refer to the Kit Components page (Page 3)
for a picture of each item.