Filter
Top Products
FIRST AID FOR SCALDS
1. Remove all wet clothing quickly. Wet clothing retains the heat.
2. Apply cold water to burned area for 30 minutes to reduce the heat in the skin and prevent deeper
burning. Never use butter, oils, or ointment to cover the burn. They may retain the heat.
3. Use a blanket to keep the scalded person warm.
4. Seek medical advice.
ERROR MESSAGES ON REMOTE TEMPERATURE CONTROL DISPLAY
The Bradford White EVERHOT® continuous flow water heaters have the ability to monitor and display
any operating faults on the control display. The error messages will display on the monitor and will assist
in servicing the water heater. The following is a listing of the error codes, which may flash on the monitor
in case of a malfunction with the water heater. Please quote the code displayed when calling for service.
Code
Displayed
Fault Remedy
10 Air supply or exhaust blockage Check for a restriction in the exhaust
vent.
11 No Ignition Check to make sure the gas supply is
on to the water heater.
12 Flame Failure, grounding failure Make sure gas is turned on at the
water heater; check for obstructions in
exhaust vent.
14 Thermal Fuse Heat exchanger overheated
16 Over Temperature Warning Excessive temperatures, wrong dip
switch setting, incorrect manifold
pressure or gas type.
32 Outlet water temperature faulty Outlet sensor or wiring may be
defective
33 Heat exchanger outlet water temperature faulty H.E. outlet sensor or wiring may be
defective.
34 Combustion air sensor faulty Thermistor or wiring faulty
52 Modulating Solenoid Valve signal abnormal Check gas control and wiring
61 Combustion Fan Failure Combustion fan or wiring faulty
71 Solenoid Valve Driving Circuit Faulty Check all gas solenoids and wiring
72 Flame Sensing Device Faulty Lack of flame sense – check flame rod
and wiring connections.
LC
(00)
Scale build-up in Heat Exchanger
(When checking maintenance code history, “00” is
substituted for “LC”).
Build up of lime scale in heat
exchanger – needs to be flushed.
If any of the above error codes are seen flashing on the remote display, call for service.
WARNING
Failure to remedy faults may result in severe burns, scalds, and/or death.
47