Filter
Top Products
39
LIGHTING INSTRUCTIONS
Figure 26.
Lighting Instruction Label
TEMPERATURE ADJUSTMENT
The temperature selector knob of the thermostat has been adjusted to 120°F (48.9ºC) when shipped from the factory.
NOTICE
The lower the temperature setting, the greater the energy efficiency, both to heat the water and to maintain the
storage temperature during standby periods. Lower water temperatures also extend tank life. Remember, no water
heating system will provide exact temperatures at all times. Allow a few days of operation at this setting to
determine the correct temperature setting consistent with the requirements for the installation.
CAUTION
This water heater, when set at a lower temperature setting is not capable of producing hot water of sufficient
temperature for sanitizing purposes.
During the winter season or any cold period, you may desire a higher temperature setting to adjust for the colder incoming water. This
adjustment, however, may cause additional condensation to form on the colder tank surface. This does not mean the tank is leaking.
During summer months, the warmer incoming water temperatures will benefit the performance of your water heater and reduce the
amount of condensation developed.
WARNING:
above on this label.
above on this label if you don't smell
Follow "B" in the safety information
If you then smell gas, STOP!
6. Wait (5) minutes to clear out any gas.
result causing property damage, personal injury or loss of life.
If you do not follow these instructions exactly, a fire or explosion may
1. Set the thermostat to lowest setting.
2. Set the thermostat to lowest setting.
1. STOP! read the safety information
TO TURN OFF GAS TO APPLIANCE
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around
the appliance for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do
not use any phone in your building.
If you cannot reach your gas,
supplier call the fire department.
C. Turn off main power to the water
heater.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been
under water.
3. Turn off all electrical power to the
appliance.
4. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by
5. Turn off the main power switch.
hand.
gas, go to next step.
7. Set the thermostat to desired setting.
2. Turn off the main power switch.
"GREEN LIGHTED" MAIN
POWER SWITCH
8. Turn on main power.
Immediately call your gas supplier
from a neighbors phone, follow the
gas suppliers instructions