Filter
Top Products
SC & SI Remote Interface Description en | 7
Bosch Security Systems B.V. | 2003 December | SC & SI Remote Interface Description
Response structure from the function
The function returns the following structure:
WORD wNrOfInstances
where:
wNrOfInstances
The value of the update use count for the SC application at the
end of the function handling. It contains the number of times a
remote PC has been connected over the same communication
medium. E.g. the first time the function SC_C_START_DCN is
called, it contains the value 1.
Error codes returned
SC_E_NOERROR
Related functions
SC_C_STOP_DCN
3.4 SC_C_STOP_DCN
Purpose
Indicates the CCU that the remote controller no longer requires updates from the SC application inside the
CCU. After receiving this function the CCU decrements the update ‘use’ count. As long as the update use
count is greater than zero, the CCU remains sending the update notifications to the remote controller.
Note that: Upon communication lost this function will be activated, if SC_C_START_DCN was
activated. The activation of this function is repeated till the update use count
becomes zero.
Availability
This function is available in CCU system modes config and congress.
Parameter structure for the function
The function has no additional parameters.
Response structure from the function
The function has the same response structure as the remote function SC_C_START_DCN (section 3.3).
Error codes returned
SC_E_NOERROR
Related functions
SC_C_START_DCN
3.5 SC_C_GET_CCU_VERSIONINFO
Purpose
This function is used to query the CCU version information. Usually this will be the first function called after
start-up of the remote controller to check the correct version of the CCU software.
Availability
This function is available in CCU all system modes.
Parameter structure for the function
The function has no additional parameters.
Response structure from the function
The function returns the following structure:
typedef struct
{
WORD tOperatingMode;
CHAR szSwVersion [SC_C_MAX_VERSION_LENGTH];
BYTE byMajorVersionOfDownloadedSw;
BYTE byMinorVersionOfDownloadedSw;
BYTE byMajorVersionOfResidentSw;
BYTE byMinorVersionOfResidentSw;
BYTE bySystemMode;
BYTE byReservedForSwInfo [SC_C_MAX_SOFTWARE_INFO];
SC_T_CCU_TYPE tCCUType;
BYTE byMTBVersion;
BYTE byTCBVersion;
BYTE byReservedForHwInfo [SC_C_MAX_HARDWARE_INFO];
CHAR szSWRelNum[VERSION_C_LENGTH];
} SC_T_CCU_VERSION_INFO;
where:
tOperatingMode
The current operating mode of the CCU. It gives information