Filter
Top Products
30 en | Basic Mode Camera Browser Interface
AM18-Q0635 | v5.6 | 2013.01 Software manual Bosch Security Systems
5.2 Date/Time
Device date, time and zone
If there are multiple devices operating in the system or
network, it is important to synchronize their internal clocks. For
example, it is only possible to identify and correctly evaluate
simultaneous recordings when all devices are operating on the
same time. Device time, date and time zone are shown.
Click Sync to PC to apply the system time from your
computer to the device.
Time server IP address
The camera can receive the time signal from a time server using
various time server protocols and then use it to set the internal
clock. The device polls the time signal automatically once every
minute.
Enter the IP address of a time server.
Time server type
Select the protocol that is supported by the selected time
server. It is recommended that you select the SNTP server
protocol. This protocol provides high accuracy and is required
for special applications and future function extensions.
Select Time server if the server uses the RFC 868 protocol.
Note:
It is important that the date/time is correct for recording. An
incorrect date/time setting could prevent correct recording.