Filter
Top Products
18 en | Operation via the browser Camera Browser Interface
AM18-Q0635 | v5.6 | 2013.01 Software manual Bosch Security Systems
Pre-position
To move the camera to a pre-position, click one of the buttons
numbered one to six.
To store the current position of the camera in a pre-position:
1. Position the camera.
2. Enter a pre-position number.
3. Click Set.
3.1.4 View Control ROI
When the stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated.
Refer to Section 9.3 Encoder Regions, page 66 for more
information on setting up stream 2. (When encoder stream 2 is
set for dual ROI, open the camera in a second browser window
to set up the second ROI on stream 2.)
Zoom
To zoom in on a region of the stream 2 image:
Click and hold to zoom in; click and hold to
zoom out.
Click to see the full image.
Select an area
To select a particular region of the image:
1. Click and hold the arrows to move up and down, and from
side to side through the image.
2. Click and hold the center area to move in all directions.