Filter
Top Products
21Bosch | 09/04 | 74-06200-000-F
PriPh#
Default: Blank
Selections: 0 to 9, B to F, or Blank
Use to select the primary receiver telephone number.
You can enter up to seven characters. Refer to Table 9 for
other dialing character selections.
When programming the primary and
alternate telephone numbers, ensure the
primary telephone number is different from
the alternate telephone number.
AltPri
Default: Blank
Selections: 0 to 9, B to F, or Blank
Blank No prefix or area code. A delay of
up to 7 sec is automatically inserted
in front of the prefix.
Use to select the prefix for the alternate receiver
telephone number. You can enter up to nine characters.
Refer to Table 9 for other dialing character selections.
AltPh#
Default: Blank
Selections: 0 to 9, B to F, or Blank
Use to select the alternate receiver telephone number.
You can enter up to seven characters. Refer to Table 9 for
other dialing character selections.
When programming the primary and
alternate telephone numbers, ensure the
primary telephone number is different from
the alternate telephone number.
12 V Mode
Default: Yes
Selections: Yes or No
Yes 12 VAC, 20 VA, 60 Hz transformer
operation.
No 24 VDC supply from an existing
FACP.
Use to enable either the 12 V Mode or 24 V Mode.
Class B Mode
Default: 3
Selections: 1 to 3
1 Mode 1 not acceptable for
stand-alone applications.
2 Mode 2 has restricted use for
stand-alone applications.
3 Mode 3 is required for most
stand-alone applications.
Use to program the operating mode for the Class “B”
Supervisory Circuits (Zones 2 and 3).
For detailed mode specifications, refer to Section 2.3
Zones 2 and 3, Supervisory Circuits beginning on page 11
for installation instructions.
Retard Time
Default: 0
Selections: 0 to 90
Use to program the retard timer for the Class “A” Alarm
Initiating Circuit (Zone 1). Enter the number of seconds
you want for the retard time. After an alarm condition is
detected on the sensor loops, the retard timer starts. An
Alarm Report is not transmitted until the retard timer
reaches the value entered in Retard Time. If the faulted
condition restores before the retard timer reaches the
value entered in Retard Time, the Alarm Report is not
transmitted.
Refer to
Section 2.2.2 Retard and Reset Times on pages 10
and 11 for details.
Refer to the appropriate NFPA
Standard or the local AHJ for acceptable retard times.
Table 9: Special Dialing Characters
Selection Dialing Effect Description
B
(*) character Accesses special
telephone features.
C
3-sec pause While dialing, inserts a
3-sec pause between
digits.
D
7-sec dial tone
wait
Waits up to 7 sec for a
dial tone before dialing.
E
(#) character Accesses special
telephone features.
F
Alternates
between
rotary and
DTMF
Used when accessing
some long-distance
carriers while using
rotary-dial phone lines.
D2071A | Operations & Installation Guide | 4.0 Program Record