Filter
Top Products
CPU Software Version Numbers
EN | 79
Figure 16: Possible Allegiant Satellite System Configurations
Any Allegiant Series switcher model (LTC 8100, LTC 8200, LTC 8300, LTC 8500,
LTC 8600, LTC 8800, or LTC 8900) can be used as a main site or a satellite site unit.
All products are standard models, and the only special requirement is to use either
the optional LTC 8059/00 MCS or the optional LTC 8850/00 GUI Software pack-
age for initial programming of each Allegiant system.
An Allegiant biphase control data line from the code distribution unit at the Main
site must be provided to each satellite site. This data line carries all pan/tilt/zoom
control commands, in addition to the switching commands generated by the Main
Allegiant
Satellite
Allegiant
Satellite
Allegiant
Satellite
Allegiant
Satellite
Allegiant
Master
Allegiant
Master
Allegiant
Master
Allegiant
Master
Allegiant
Master
Allegiant
Satellite
Allegiant
Master
Allegiant
Satellite /
Master
Allegiant
Master
Allegiant
Master
Typical Master / Multiple Satellite Configuration
Dual Master Configuration
Quadruple Master Configuration
All
eg
i
an
t
S
a
t
e
llit
e
C
oncep
t
s
Satellite / Master can view / control local and Satellite’s cameras
‘Cascaded’ Satellite Configuration
All Masters can
view / control
all cameras
Satellite
can view /
control
only local
cameras
Master can view
/ control all
cameras
Both
Masters can
view /
control all
cameras
Satellite can view /
control only local
cameras