Filter
Top Products
EN | 52 Bosch Security Systems | December 13, 2005
Programming a SalvoSwitching Camera Sequence
A SalvoSwitching sequence can be used to switch a group of monitors simulta-
neously as a synchronized group. To program a Salvo sequence, enter the program-
ming mode as described above for a simple camera sequence. By definition, Salvo
sequencing involves more than one monitor. An example of a simple Salvo
sequence that switches cameras on three (3) monitors simultaneously is shown
below:
In general, follow the instructions used for the simple camera sequence (described
above), but instead of entering a number of seconds for steps that must switch
instantly, enter 61 and press [Enter]. This causes the switcher to automatically
change to the salvo abbreviation SLV. Dwell time (in seconds) is entered only when
you reach the step containing the last monitor that will be switched within the syn-
chronized group.
CAMERA MONITOR DWELL
1 1 SLV
2 2 SLV
3 3 2
7 1 SLV
8 2 SLV
9 3 2
21 1 SLV
22 3 SLV
23 3 2