Filter
Top Products
Video Output Modules
EN | 17
7. 3Video Output Modules
Counting from left to right beginning with slot 9, install the appropriate number of
Video Output Modules (VOM) into these slots. If fewer than the maximum number
of VIMs are installed, there will be empty slots between the Input and the Output
Modules, so make sure that the Output Modules are inserted into the correct slots.
Figure 4: Typical Video Output Module Insertion
All VOMs are identical and are interchangeable within the designated VOM slots.
7. 4CPU Module
The slot to the left of the power supply in the main CPU bay is reserved for the sys-
tem CPU module.
NOTE The CPU module contains two (2) lithium batteries mounted on the component
side of the printed circuit board. A red rectangular insulating tag may be
installed in between the top of the batteries and the battery holder clip. This tag
prevents battery drainage during stocking. Remove tag if so equipped.
Figure 5: Typical CPU Module Insertion
Install the main bay CPU at this time.
The circuit board contains two (2) 8-position DIP switches for system configuration
options. The DIP switches can be used to modify certain system operating condi-
tions. Review the Factory Default Settings Section to determine if it is necessary to
change the DIP switches from the factory default positions. For reference, the fac-
tory default settings are:
DIP Switch S1001 All OFF
DIP Switch S1002 Switch 5 ON, 7 ON, and 8 ON; All others OFF