Filter
Top Products
9
When It’s Time to Empty Tank-in-Tank
1.
2.
3.
4.
5.
6.
7.
8.
9.
Tip:
Thorough
vacuuming
before deep
cleaning will
prevent early
clogging of
lint trap.
Tip:
A special red
float device
in the tank will
cause the cleaner
to stop removing
solution from the
carpet and the
motor sound will
rise in pitch to let
you know the
dirty water tank is
full.
Remove the Tank-in-Tank – follow steps 1 and 2
on page 8.
Carry the Tank-in-Tank, like a bucket, to the sink where you
will dispose of the dirty water.
Remove Tank Lid by rotating handle forward to unlatch lid and
lifting lid off tank.
Pour out dirty water.
After each use, remove and rinse the lint screen located on
the Tank Lid.
A. Remove Tank Assembly from unit.
B. Remove Tank Lid.
C. Remove any debris caught in Lint Screen.
D. Reinsert Lint Screen on Tank Lid. The screen will click
into place
E. Replace Tank Lid.
F. Reinsert Tank Assembly into unit.
Refill with clean tap water as above, steps 5 through 9 on
page 8, and refill the SmartMix bottle with BISSELL Deep
Cleaning Formula as necessary.
When the cleaning job is complete, rinse out the
Tank-in-Tank by rinsing clean water between the Bladder and
tank.
Return Tank-in-Tank to the machine, following steps 6 through
9 (on page 8).
Refer to the Maintenance section, page 18 for the
final cleanup.
3
5D
Rotate Handle to
Unlatch
Fill bladder
only with clean
hot tap water
5C
Lint Screen
Pour out
dirty water
4
6
3
Latched
8